Monthly Archives: September 2016


Bonds and Matrics of Diamond Blade

Diamond blade bonds, sometimes known as matrices, are central to the diamond blade’s performance. Many diamond blade performance secrets lie in this high tech area. Some diamond blade manufacturers develop their bonds in house, others buy bonds from bond manufacturers, others use bonds under license, and some combine all three. To perform well, a bond [...]

By |2016-09-23T15:40:42+00:00September 23rd, 2016|Blog|Comments Off on Bonds and Matrics of Diamond Blade

9 Normal problems in using diamond saw blade

During the process of using diamond saw blade, there are always some problems will occur, some are the defect of the blades, some are caused by the improper use. Below are 9 normal problems caused by the improper use of blade, but not the responsibility of the diamond blade manufacturer. 1.SEGMENT LOSS CAUSE: [...]

By |2017-12-07T13:22:15+00:00September 21st, 2016|Blog|Comments Off on 9 Normal problems in using diamond saw blade

How to cut asphalt properly

Cutting asphalt is easier than cutting cured concrete but diamond blade selection is important if long life is to be achieved. Asphalt is generally relatively soft. Asphalt cutting can be tricky, not because it is hard to cut, but because it is too easy. Asphalt is composed of more than 90% aggregates and a petroleum [...]

By |2016-09-23T15:43:28+00:00September 20th, 2016|Blog|Comments Off on How to cut asphalt properly

How to choose the right diamond blade

Before you are looking to buy a diamond blade, it is necessary for you to take some time to reserch various options, as choosing the wrong one could result in decreased efficiency, increased cost and project downtime. Choosing the right blade will make the process of cutting material smoother and safer as well as provide [...]

By |2016-12-16T06:07:12+00:00September 20th, 2016|Blog|2 Comments
Go to Top